I have configured Fanaleds 2.3 as i have seen in the manual-video.
The Hardware that i use is the Fanatec Wheelbase V1 and the BMW-Rim.
Now i want the right Rotary-Encoder to use for switching profiles.
I go to my GT-Legends Profile, take hardware an select my wheel.
Then i click on Learn Switches and turn the Rotary-Encoder in both directions.
Select them and assign it. Then i have 2 Profiles generated.
I pick what i want in the profiles and then i click on < and turn the Rotary-Encoder left.
Same for the other Side. But this time i turn right.
Close the window and save to the active profile. But i can't switch the profiles.
It also don't work when i use other buttons. Also i can set to 3 profiles. It makes no difference.
Here ist my Save-File:
Code: Select all
<?xml version="1.0" encoding="ISO-8859-1" ?>
<config>
<!-- Sample XML config file for Fanatec Leds -->
<!-- Supported modes are: speed, gear, speedgear, fakerevs and fuel. Default is speedgear -->
<!-- Supported gauges are: kph and mph. Default is kph -->
<!-- If the telemetry of a game doesn't allow a particular mode it will revert back to default GEAR mode -->
<settings mode="gear" gauge="kph" joyID="0" buttonID="0">
<insim ip="127.0.0.1" port="29999" pass="" enabled="false" />
<outgauge ip="127.0.0.1" port="30000" />
<outsim ip="127.0.0.1" port="30500" />
</settings>
<!-- Flash frequencies can be any value between 50ms and 5000ms, with steps of 50ms -->
<lights>
<shiftlights frequency="200" flashbrackets="yes" revleds="yes" rpmperc="84" />
<pitlights frequency="500" />
<fuelempty frequency="500" percentage="10" />
</lights>
<rumble>
<brakepedals on="yes" threshold="100" />
<brakewheel on="yes" />
<shift on="yes" />
<engine on="no" />
</rumble>
<cars>
<car type="default" first="0" second="0" third="0" max="0" shift="0" final="0" threshold="0" angle="0" />
</cars>
</config>
It would be very nice.
But any Way. Great Software! I use it every time i drive.
Kindly Regards
Reto
